Pyle PLA4988 4 Channel 6000 Watts Bridgeable Mosfet Amplifier
Good for the price!
Its a great amp for the price, but it is everything short of 6000 watts. Had all of my inside speakers and two pyle driver 3200 watt 12's in the back connected to it. It played fine for about six months and after that the protect light started coming on, and eventually stayed on. I had an expert take it apart, and the terminals that the subs where connected to were fried. So if your looking for a four channel amp to power your whole system i wouldn't advise this particular amp.
Pyle PLA4988 4 Channel 6000 Watts Bridgeable Mosfet Amplifier Features
- Maximum Power Output 4 x 1500W - 2 Ohm Stable - Custom Terminal Block for Speaker Connection - S/N Ratio: >90dB
- Bridgeable RMS Power @ 4 Ohms: 2 x 3000 W - MOSFET Power Supply - Thermal / Overload / Short Circuit Protection - Dimensions:9.76'' W x 2.99'' H x 16.93'' L
- 4 Channel Bridgeable MOSFET Amplifier - PWM ( Pulse-Width-Modulation ) System - Input Impedance: 47K Ohms
- Frequency Response 20 Hz-50kHz (±3dB) - Glass Epoxy PCB - Soft Turn On/ Off
- Output Power @ 14.4v DC, 50Hz - Silver RCA Inputs - Advanced Protection Circuitry
Pyle PLA4988 4 Channel 6000 Watts Bridgeable Mosfet Amplifier Description
Description : When power isn’t enough, you need Pyle Super Power. This four-channel, 6000-watt power supply is bridgeable. It’s equipped with everything you’ve come to expect from quality car amplifiers. The RCA ports are silver-plated for eliminating signal loss. A subsonic filter allows low-end interference to be cut, so your speakers will always be delivered the highest quality audio. The MOSFET pulse width modulation power supply allows for a clean, distortion-free signal to your speakers. To keep both your car and the amplifier safe, this model is equipped with thermal, overload, and short circuit protection. So when what you need is power, trust Pyle Super Power.
0 comments:
Post a Comment